Are you looking for:
|
Accelerator Cable Clip / Throttle Linkage Clip for Ball Socket (Fiat Lancia All) - OE / RENEWED
Factory OE throttle cable / linkage / rod end retention clip as fitted to most Fiat and Lancia cars.
Condition: OE NOS / RENEWED
Either Original Equipment New Old Stock.as supplies permit or a clean used unit freshly replated in yellow zinc.
|
Console Center Lower Vent Grille Pair Left/Right - Beige (Fiat Pininfarina 124 Spider All) - U8
This is a left and right side pair of grilles that are fitted in the cut-outs of Fiat 124 Spider and Coupe lower center consoles.
Beige (tan) in color.
These rectangular areas in the console were left blank from the factory for all Fiat 124 Coupe cars, and for 124 Spider through 1978.
In 1979, 124 Spiders began being fitted with these grilles, but most were kicked out and lost long ago.
Condition: USED (8 of 10)
Good used condition.
|
Performance Camshaft DOHC 232 Degree w/Exhaust gear(Fiat 124, 131, Lancia Beta, Scorpion) - NEW
This is a single Fiat or Lancia DOHC performance camshaft, with distributor drive gear, with higher duration than a typical stock camshaft, great for street performance or mild autocross.
Application(s):
Fiat 124, 131, Lancia Beta Intake:
Use on all applications.
Fiat 124, 131, Lancia Beta Exhaust:
Use on all applications running a vertical distributor on the exhaust cam bank.
Critical Specifications:
Duration: 232 degrees @ .050 lift
Lift: 10.42mm
Lobe center: 108.2deg
Base circle: 24.75mm (+.675 mm nominal clearance)
CLICK ON THE PHOTO FOR ACCESS TO A DETAILED SET-UP / SPEC SHEET
Application(s)
Fiat 124 (All DOHC Exhaust)
Fiat 131 (All DOHC Exahaust)
Lancia Beta (All DOHC Exhaust)
Condition: REGRIND
Freshly reground.
|
Steering Wheel - 15" Wood Grain (Fiat 124 Spider 1973-78, 124 Coupe 1973, 850 Spider 1973) - U8
This is a Factory OE steering as fitted to 1973-on Fiat 124 Spider. Wood grain outer surround.
Condition: USED (8 of 10)
Good used condition. No cracks on the outer wheel. Finish on inner basket shows some age and may need a quick repaint.
|
Marker Light Red SIEMA (Fiat X1/9, 124, 128, 131, 850, Lancia, Ferrari, Maserati) - OE NOS
This is a F/I/A/T Factory OE red NA-spec (rectangular) marker light for the rear fenders of all 1971-88 Fiat and Lancia vehicles; including Fiat Bertone X1/9, Fiat Pininfarina 124, 131, 128, 850, Lancia Beta, Scorpion - and Ferrari vehicles.
Not a replica reproduction lens (all of which are cosmetically inferior to factory unit).
Made by SIEMA. Factory issue fitted on most Fiat and Lancia vehicles 1979-on, but can be fitted to earlier models.
Will accept an early-style Altissimo/Carello bulb holder, or a later locking-style SIEMA pigtail.
Application(s)
All models 1971-88
Condition: OE NOS
Original Equipment New Old Stock
New and Unused
|